Assign IPv6 Addresses to a Brouter Port or VLAN
Assign IPv6 addresses to interfaces to configure IPv6 routing for the interface.
Procedure
Example
Assign an IPv6 address specifying the full 128 bits of the address:
Switch:1>enable Switch:1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch:1(config)#interface gigabitethernet 1/5 Switch:1(config-if)#ipv6 interface address 30:0:0:0:0:0:0:ffff/64
Variable Definitions
The following table defines parameters for the ipv6 interface address command.
Variable |
Value |
---|---|
WORD<0–255> |
Specifies the IPv6 address for the port or VLAN. |
The following table defines parameters for the interface command.
Variable |
Value |
---|---|
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} |
Identifies the
slot and port in one of the following formats:
|